3D Printed right in our workshop.
-PPA-CF Custom NA Socket - For torquing foot stud on all Fox NA1/2/3 air springs, rated for up to 100in/lb at room temp, 60in/lb on a 100°C part. More than plenty for the 50in/lb torque spec. Printed using PPA-CF (Premium Carbon Fiber Reinforced Polyphthalamide) for superior stiffness and heat resistance.
-CF Hex Clamp for Fox GRIP X2 - Clamps upper and lower pressure tubes together for top cap removal, and prevents damage to the thin hex flats! Slight interference fit (~0.1mm) for even 360° load distribution at high clamping loads. Printed with carbon fiber-reinforced Nylon and annealed right after printing to further increase toughness.
-CF Hex Clamp for Fox GRIP X - Same as above, but for GRIP X. Streamlines service process and prevents damage to the thin hex flats! Printed with carbon fiber-reinforced Nylon and annealed right after printing to further increase toughness.
-Hex Clamp for Fox Transfer (MY25+) - Securely clamps inner pressure tube for sealhead removal, prevents damage to the thin hex flats!
-Fox pellet cuting guide - Make your own pellets for Fox shocks from 7mm o-ring cord, gets the perfect cut every time.
More coming soon…
3D Printed right in our workshop.
-PPA-CF Custom NA Socket - For torquing foot stud on all Fox NA1/2/3 air springs, rated for up to 100in/lb at room temp, 60in/lb on a 100°C part. More than plenty for the 50in/lb torque spec. Printed using PPA-CF (Premium Carbon Fiber Reinforced Polyphthalamide) for superior stiffness and heat resistance.
-CF Hex Clamp for Fox GRIP X2 - Clamps upper and lower pressure tubes together for top cap removal, and prevents damage to the thin hex flats! Slight interference fit (~0.1mm) for even 360° load distribution at high clamping loads. Printed with carbon fiber-reinforced Nylon and annealed right after printing to further increase toughness.
-CF Hex Clamp for Fox GRIP X - Same as above, but for GRIP X. Streamlines service process and prevents damage to the thin hex flats! Printed with carbon fiber-reinforced Nylon and annealed right after printing to further increase toughness.
-Hex Clamp for Fox Transfer (MY25+) - Securely clamps inner pressure tube for sealhead removal, prevents damage to the thin hex flats!
-Fox pellet cuting guide - Make your own pellets for Fox shocks from 7mm o-ring cord, gets the perfect cut every time.
More coming soon…
